Transformateur d'éclairage RS PRO 150 W Borne à vis Transformateur électronique à intensité réglable Vis, Vin 230 to 240
Documents techniques
Spécifications
Brand
RS ProType du produit
Light Transformer
Primární napětí
230 to 240 V ac
Tension secondaire
12 V
Napájecí
150W
Exigence d'une charge minimale
30W
Maximální provozní teplota
60°C
Température minimum de fonctionnement
40°C
Sous type
Dimmable Electronic Transformer
Type de terminaison
Screw
Typ montáže
Šroubová svorka
Profondeur
39mm
Longueur
190mm
Masse
205g
Normes/homologations
EN 61347-2-2, VDE 0710-T14, EN 61347-1, EN 61547, EN 55015, EN 60598-1, EN 61000-3-2
Largeur
124mm
Série
WOLF 150 - WX 150
Méthode de gradation
Trailing Edge
Fréquence d'utilisation maximale
60Hz
Fréquence de fonctionnement minimale
50Hz
Pays d'origine
Italy
Détails du produit
Low Voltage Lighting Transformers
Dimming Methods (where applicable):
Leading Edge:
The control device is either a thyristor or triac which blocks power until they are switched on by the control signal. At that point the current flows almost instantaneously and continues to flow until the end of the half cycle of the mains waveform. When the signal reaches zero, the device turns off and no more current is passed until it is triggered again. Turning the power on and off in this manner averages out creating a constant intensity level and by altering the precise trigger point over a period of time the lamp can be dimmed.
Trailing Edge:
Since this method of dimming uses transistor technology it is not limited to just switching, therefore current can be controlled gradually. Transistors can be programmed to pass current at the start of each half cycle, and gradually switch off later. This will control the full amount of power reaching the lamp without the side effects of a step increase in current.
Les informations sur le stock sont temporairement indisponibles.
€ 29,98
€ 29,98 Each (hors TVA)
1
€ 29,98
€ 29,98 Each (hors TVA)
Les informations sur le stock sont temporairement indisponibles.
1
Documents techniques
Spécifications
Brand
RS ProType du produit
Light Transformer
Primární napětí
230 to 240 V ac
Tension secondaire
12 V
Napájecí
150W
Exigence d'une charge minimale
30W
Maximální provozní teplota
60°C
Température minimum de fonctionnement
40°C
Sous type
Dimmable Electronic Transformer
Type de terminaison
Screw
Typ montáže
Šroubová svorka
Profondeur
39mm
Longueur
190mm
Masse
205g
Normes/homologations
EN 61347-2-2, VDE 0710-T14, EN 61347-1, EN 61547, EN 55015, EN 60598-1, EN 61000-3-2
Largeur
124mm
Série
WOLF 150 - WX 150
Méthode de gradation
Trailing Edge
Fréquence d'utilisation maximale
60Hz
Fréquence de fonctionnement minimale
50Hz
Pays d'origine
Italy
Détails du produit
Low Voltage Lighting Transformers
Dimming Methods (where applicable):
Leading Edge:
The control device is either a thyristor or triac which blocks power until they are switched on by the control signal. At that point the current flows almost instantaneously and continues to flow until the end of the half cycle of the mains waveform. When the signal reaches zero, the device turns off and no more current is passed until it is triggered again. Turning the power on and off in this manner averages out creating a constant intensity level and by altering the precise trigger point over a period of time the lamp can be dimmed.
Trailing Edge:
Since this method of dimming uses transistor technology it is not limited to just switching, therefore current can be controlled gradually. Transistors can be programmed to pass current at the start of each half cycle, and gradually switch off later. This will control the full amount of power reaching the lamp without the side effects of a step increase in current.